Wireless 8 zone remote control brightness dimmer RU8 is used with single or many L4-M receivers, connected to DLC-D series LED drivers to power up ELS-L series LED lights. To launch LED lights brightness control:

1. connect L4-M receiver's output with DLC-D driver's 0-10V input
2. connect L4-M to power source ~230V AC or 12-24V DC
3. remove protective film from RU8 battery
   
4. match RU8 dimmer and L4-M

Then all four steps are complete, simply press and hold zone key to increase brightness of selected zone or release and press zone key to decrease it . Short press zone key to turn LED light ON or OFF. Press top key with "ON All" marking to turn all 8 zones ON or "OFF all" to turn them OFF.

Each Wireless 8 zone remote control dimmer RU8 can match with one or many receivers. To simultaneously control all available DLC-D drivers just match RS1 with every L4-M receiver, or split into 8 separate zones.

Matching remote control and receiver

There is two options to match/delete devices:

• Use the controller’s Match key
• Use Power Restart

1) Controller’s match key:

• Match: Short press "Match" key on L4-M controller and immediately press selected zone key on RU8 . If blue "RUN" light on controller blinks 3 times match is successful.
• Delete: Press and hold "Match" key for 5s to delete all matched devices. When blue "RUN" light blinks 5 times all matched devices are deleted.

2) Power Restart:

• Match: Switch off the power, then switch power ON again. Immediately press selected zone key on RU8 3 times. If blue "RUN" light on controller blinks 3 times match is successful.
• Delete: Switch off the power, then switch power ON again. Immediately press selected zone key on RU8 5 times. When blue "RUN" light blinks 5 times all matched devices are deleted.