Wireless 1 zone magnetic brightness dimmer R1-1 is used with single or many L4-M receivers, connected to DLC-D series LED drivers to power up ELS-L series LED lights. To launch LED lights brightness control:

1. connect L4-M receiver's output with DLC-D driver's 0-10V input
2. connect L4-M to power source ~230V AC or 12-24V DC
3. remove protective film from R1-1
4. match R1-1 dimmer and L4-M

Then all four steps are complete, simply push and hold key to increase brightness, and push and hold it again to decrease. Short push key to turn LED light ON or OFF.

Each R1-1 magnetic wireless dimmer can match with one or many receivers. To simultaneously control all available DLC-D drivers just match R1-1 with every L4-M receiver.

Matching dimmer and receiver

There is two options to match/delete devices:

• Use the controller’s Match key
• Use Power Restart

1) Controller’s match key:

• Match: Short press "Match" key on L4-M controller and immediately push key on R1-1 . If blue "RUN" light on controller blinks 3 times match is successful.
• Delete: Press and hold "Match" key for 5s to delete all matched devices. When blue "RUN" light blinks 5 times all matched devices are deleted.

2) Power Restart:

• Match: Switch off the power, then switch power ON again. Immediately push key on R1-1 3 times. If blue "RUN" light on controller blinks 3 times match is successful.
• Delete: Switch off the power, then switch power ON again. Immediately push key on R1-1 5 times. When blue "RUN" light blinks 5 times all matched devices are deleted.